Quendil wrote:
I superglued pennies to the bottom of the base
I did this
| The One Ring https://wap.one-ring.co.uk/ |
|
| Metal Ringwraith on Fellbeast https://wap.one-ring.co.uk/viewtopic.php?f=30&t=24461 |
Page 1 of 1 |
| Author: | Fawful [ Fri Dec 14, 2012 12:18 pm ] |
| Post subject: | Metal Ringwraith on Fellbeast |
I've had this model for quite some years now, got it new out of the box. Assembled it and found out that it isn't stable. Atleast for me my model hangs a bit to the right, while it's glued in the middle of the base. Anyone else encountered this with his model or knows a solution? |
|
| Author: | Finrod [ Fri Dec 14, 2012 12:31 pm ] |
| Post subject: | Re: Metal Ringwraith on Fellbeast |
Try putty in its base, worked for my easily falling Balrog. |
|
| Author: | Erunion [ Fri Dec 14, 2012 3:05 pm ] |
| Post subject: | Re: Metal Ringwraith on Fellbeast |
You could also try a large metal washer glued to the base. |
|
| Author: | SidTheSloth [ Fri Dec 14, 2012 3:53 pm ] |
| Post subject: | Re: Metal Ringwraith on Fellbeast |
Some largish rocks when you do the basing? |
|
| Author: | GothmogtheWerewolf [ Fri Dec 14, 2012 8:04 pm ] |
| Post subject: | Re: Metal Ringwraith on Fellbeast |
I did two things: 1. don't put it in the centre of the base, to balance out it needs to be further back. 2. also added a large rock at the front of the base. |
|
| Author: | Leonardis [ Fri Dec 14, 2012 8:49 pm ] |
| Post subject: | Re: Metal Ringwraith on Fellbeast |
Quendil wrote: I superglued pennies to the bottom of the base I did this
|
|
| Author: | Dorthonion [ Sat Dec 15, 2012 7:41 am ] |
| Post subject: | Re: Metal Ringwraith on Fellbeast |
And try not to drop it or knock it off a table or shelf (like I did). Metal has so much mass that breakages are inevitable even in a short tumble. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|