| The One Ring https://wap.one-ring.co.uk/ |
|
| question about painting finecasts https://wap.one-ring.co.uk/viewtopic.php?f=30&t=22514 |
Page 1 of 1 |
| Author: | geezer of rhun [ Tue Feb 21, 2012 1:39 am ] |
| Post subject: | question about painting finecasts |
Hello All, I have a simple question about the finecasts and painting. Do you need to prep (wash in warm soapy water, fine scour the surface, then use resin primer before painting? I know from working with resin models that this step is very important to help adhesion of paint. Thanks GoR |
|
| Author: | Erunion [ Tue Feb 21, 2012 2:15 am ] |
| Post subject: | Re: question about painting finecasts |
I have only purchased one Finecast model, the Terminator Librarian from 40K, and these steps were not necessary. I did check for mould release agent, and when I did not find any, I assembled the model and primed with my normal spray primer. There were no problems with paint adhesion, but it is a small sample. Your mileage may vary... |
|
| Author: | valpas [ Tue Feb 21, 2012 6:55 am ] |
| Post subject: | Re: question about painting finecasts |
Jonathan, how do you check for mould release agent? Is it visible? I assumed Finecast does not require special preparation because I didn't see any special instructions on GW's site. I had some paint adhesion problems with Sauron, but I assumed it was because I had primed it in quite cold conditions (didn't have any choice). -- Pasi |
|
| Author: | Dead Marsh Spectre [ Tue Feb 21, 2012 7:26 am ] |
| Post subject: | Re: question about painting finecasts |
Definately wash finecast before priming - I didn't wash gulavhar and had a nightmare getting the paint to adhere |
|
| Author: | Caputo [ Tue Feb 21, 2012 9:43 pm ] |
| Post subject: | Re: question about painting finecasts |
Yep definately wash it. |
|
| Author: | Erunion [ Wed Feb 22, 2012 1:59 am ] |
| Post subject: | Re: question about painting finecasts |
The mold release agent, if I'm not just goofy, is a shiny, oily film. I have only seen it in some of the deeper crevices of certain models. I very rarely find a model that needs to be washed, and I rarely have paint adhesion problems. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|