The One Ring https://wap.one-ring.co.uk/ |
|
Tiny drill bits? https://wap.one-ring.co.uk/viewtopic.php?f=30&t=17968 |
Page 1 of 1 |
Author: | theOneRider [ Tue Mar 30, 2010 2:10 pm ] |
Post subject: | Tiny drill bits? |
Hey, guys. I'm having trouble replacing my smallest drill bit. I don't have an accurate enough caliper to know the size, but I think it's somewhere between 0.1mm and 0.5mm. Does anybody know where I can get hold of a replacement or thirty? |
Author: | Dorthonion [ Tue Mar 30, 2010 6:00 pm ] |
Post subject: | |
I am guessing you are in the US? Over here in GB or Ireland I would try Maplin or any number of online retailers that have sets of fine bits for pin-vices or twist drills. Try searching using the bit sizes you are after. |
Author: | Nygyll of Wyvernhole [ Tue Mar 30, 2010 6:25 pm ] |
Post subject: | |
I have a local hardware store that does very small drill bits, very cheap. Somehow I doubt if they have a branch in the US however, but something similar may do or you. |
Author: | geezer of rhun [ Tue Mar 30, 2010 8:09 pm ] |
Post subject: | |
I use a local hobby store for fine small bits. The big box stores usually don't carry them. Good luck! |
Author: | theOneRider [ Wed Mar 31, 2010 1:53 am ] |
Post subject: | |
I found an online dealer called Micro-Mark Here They're a little expensive, perhaps, but they've got exactly what I needed. Thanks for the encouragement, guys. I've been looking for a few weeks now & couldn't find anything. I actually grabbed the ArmyPainter vice at my local game supply, hoping it had a bit small enough. It does not, but I'm not sorry I got the tool, because it's a lot nicer than the exacto brand vice I've been using. |
Page 1 of 1 | All times are UTC |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |